The LG-phone is restarting because the operating system is experiencing a crash which causes a lot of errors. The operating system may have been affected by a virus or malware, or it may have an issue with its battery or battery life.
What seems to be the issue with your device?The operation of a mobile phone or any other electronic device can be interrupted or have an error if the software installed on it is not functioning properly. A phone could keep restarting without stopping because of corrupted firmware, which needs to be fixed by reformatting the whole memory used by the device.
Once the user enters in their password, they should go to Settings > General > Reset > Erase All Content and Settings. They then need to choose “Erase All Content and Settings” again, then the phone will restart into regular mode.
The LG G3 is a phone with a quad-core CPU. You can fix it from restarting by updating the software. It’s best to do so via a Windows PC, as the files may be too large for your phone to download itself.
Boot loop is a serious problem that has been faced by users of handheld devices. Boot loops occur when the device, such as a laptop or tablet, starts to load and then repeatedly restarts without booting up fully. This can be caused by hardware failing inside the device, such as the battery malfunctioning and not holding a charge. If improper software is installed on the device it may also cause boot loops to occur.
Boot loop often can fix itself, but it needs to be restarted by the user. Boot loop is a continuous software loop that occurs when an operating system cannot load and continuously restarts without an error message. The cause of boot loops vary, and may occur because there is not enough space on the disk drive or if a program or process has been corrupted. Boot loops will usually fix themselves and require no intervention from the user.
To fix your stuck LG phone logo, first open up the device by removing the back panel. Next, use a paperclip to navigate through its various depths, searching for the “logo.” Upon finding it, lightly press on the logo with your index finger to break the seal. This should allow you to turn off and then boot into recovery mode, at which point you will need to select “wipe data/factory reset” followed by “yes.
